SeaDaq

Technical Specification

The following table summarises the technical specification for both the SeaDaq ATM SONET data acquisition system. For further information please contact the sales department at kcsales@keynescontrols.com

The system connects to standard commercial ATM network

PARAMETER	SPECIFICATION

Network
Network Standard	ATM SONET
Network Speed	155.52 MBaud
Physical layer	STM-1

Analog input
Input Type	Differential
Ranges	2V, 500mV, 200mV
No. Of Channels	8
Resolution	24 bit
Dynamic Range	140 dB
CMRR	80dB
THD	90dB
Offset Voltage	100uV
Offset Voltage Drift	5uV/C
Wideband input noise	10nV/Hz
Low frequency input noise	10uV pk-pk

Timing
Clock Stability	20ppm (note1)
ADC Clock jitter	500ps
ADC Sample Rate	8Khz .. 96KHz (note2)

Digital I/O
Output Ports	2
Output Standard	TTL

Power	6 W Maximum
Voltage Supply Range	8-15V (12V nominal)
Load	500mA

Notes

Timing is derived from ATM clock. This is 20ppm for a stratum 3 clock signal
In 8 KHz increments

The information provided in this documentation reliable at the time of the web page creation. However, KEYNES CONTROLS assumes no responsibility for inaccuracies or omissions on the use of this information, and all use of such information shall be entirely at the users own risk. Prices and specifications are subject to change without notice. No patent rights or licences to any circuits described herein are implied or granted to third party. KEYNES CONTROLS does not authorise or warrant any KEYNES CONTROLS products for use in life support or aircraft control applications.

Send comments to: Webmaster